OEM 2009 Chevrolet Equinox Ignition Lock Cylinder

2009 Chevrolet Equinox Ignition Lock Cylinder Parts and Q&A

• Q: How to replace the ignition lock cylinder on 2009 Chevrolet Equinox?

  A: Before you replace the ignition switch lock cylinder, first, disconnect the negative Battery Cable. The steering column trim covers and the wipers/washer switch should be removed, then the system should be disabled to shut down the sir system. Turn the Ignition Lock Cylinder unto run position. There are two retainers along the Ignition Lock Cylinder; pull both to take it out of the housing. Perform this action using a small allen wrench or some other small pick type tool in order to depress the first retainer through the lock housing access hole, resulting in the backing out of the lock cylinder to a certain extent. Secondly, press the second retainer in through the lock housing access hole to back the cylinder again. Pull the lock cylinder back enough to be able to reach the second retainer in hole and press it again. If the ignition cylinder does not unlock, you might need to move it in and out a couple of times to find the retainer. After cutting, take out a lock cylinder from the housing of the lock. In installation, align with the new lock cylinder in run position and insert the lock housing, making sure it rotates properly. Replace the wipers/washer switch and the steering column trim covers. Finally, turn on the sir system and reconnect the negative Battery Cable.