As a means of replacing the multifunction Turn Signal Switch housing, the start of the exercise should begin with the disarming of the sir system with the proper adequacy being exercised. Next, pull out the
Steering Wheel from the column, followed by the ignition lock cylinder case assembly. Next, remove the Turn Signal Switch assembly and the multifunction switch, and then carefully slide off the Turn Signal Switch housing from the steering column assembly. For installation slide the new Turn Signal Switch housing onto the steering column shaft assembly in such a way that it presses onto the steering column tilt head for proper aligning of the screws of the turn signal and multifunction switch assembly. After that, install turn signal and multifunction switch assembly, ignition lock cylinder case, then reinstall the Steering Wheel onto the column. When everything is done, turn the sir system on.