OEM Chevrolet Prizm Power Steering Hose

Chevrolet Prizm Power Steering Hose Parts and Q&A

• Outlet Pipe
  94857847
  Q: How to Service and Repair a Power Steering Hose for Outlet on Chevrolet Prizm?

  A:

  First service all power steering line/hose work by draining the power steering fluid from the reservoir through a siphon device. Unfasten the hose clamp connected to the intermediate outlet pipe at the power steering gear outlet hose before disconnecting both the hose and pipe from the steering gear and intermediate outlet pipe. Begin the installation procedure by connecting the power steering gear outlet pipe/hose to the steering gear before tightening the pipe fitting to 13 nm (9 ft. Lbs.). Begin the installation by clamping the power steering gear outlet pipe/hose to the intermediate outlet pipe. Add power steering fluid to your reservoir before bleaching the power steering system correctly to operate properly.
• Power Steering Pressure Hose
  94857848
  Q: How to replace the Power Steering Hose for the Reservoir Inlet on Chevrolet Prizm?

  A:

  The first step to replace the Power Steering Reservoir inlet pipe or hose is to drain the power steering fluid through a siphon into a drain pan which you place beneath the vehicle to collect fluid remnants. Disengage the two pipe clip bolts and loosen the clamps of the inlet and outlet hoses connected to the power steering fluid reservoir. Begin by unplugging both reservoir hoses while you should loosen and detach the outlet pipe at the power steering pump. The next step involves loosening the clamp by the inlet hose at the intermediate outlet pipe before removing the inlet pipe/hose from that location. You should take out both the power steering fluid reservoir pipe/hose with its clips and the outlet rear pipe from the vehicle. The process of installation begins by putting the power steering fluid reservoir pipe/hose and outlet rear pipe onto the vehicle while securing them using two pipe clip bolts that remain untightened. Install the inlet pipe/hose to the intermediate outlet pipe before applying the hose clamp while you proceed with installing the outlet hose to the power steering pump and securing it with a hose clamp. Place both hoses on the power steering fluid reservoir and fasten them with two hose clamps before tightening the two pipe clip bolts to 5.4 nm (48 inch lbs.). The power steering system requires fluid addition to the reservoir and needs appropriate bleeding procedures.